50mm x 18.3m Self Adhesive Anti-slip Tape #36 Grade non-slip Grit – Black



ANTI-SLIP SELF-ADHESIVE TAPE #36 Technical Data Sheet Introduction The Floorsafe Anti-slip self-adhesive grip tape has the highest possible safety rating and is particularly suitable for both internal & external applications. Used extensively on steps, stairways and ramps the product exceeds the requirements of the Australia/New Zealand Standards for anti-slip AS4586:2013 Appendix ‘A’. Slip resistance classification of new pedestrian surface materials and the National Construction code. Slip tests carried out under AS4586:2013 had an average slip resistance value (SRV) of 80 and slip resistance Classification P5 (Clear SRV: 46 with a clear slip resistance classification of P4) Compliance Floorsafe Australia’s Anti-slip tapes comply with the following standards  National Construction Code o Section D2.13 o Section D3.3  Australian/New Zealand Standards AS1428.1 – 2009 Design for access and mobility o Each step shall have a strip not less than 50mm and not more than 75mm deep across the full width of the path of travel. The strip may be set back a maximum of 15mm from the front of the step. The strip shall have a minimum luminance contrast of 30% to the background.  Australian/New Zealand Standards AS1428.2 – 1992 Design for access and mobility Application  To be applied to surface where there may be a safety hazard due to slipperiness either in or outdoors  Any non-porous surface void of dust, oil, water and other contaminants  Tape must be applied to a clean, dry, grease & dust free surface.  Cleaning surface with Acetone will remove all contaminants without leaving a residue.  Very smooth & high gloss surfaces should be lightly scuffed using a wet & dry abrasive pad or sand paper followed by cleaning.  We recommend where possible to apply the tape when temperatures are above 15C.  Remove the release paper and press firmly into position to obtain maximum benefit from the pressure sensitive adhesive.  For best results all finished square edges should be cut and left rounded.  Rolling over the tape with a rubber roller as it is applied will remove any entrapped air and will aid adhesion Primer  Aid adhesion using Floorsafe Australia’s Surface Primer Technical Data  Barrier carrier: PVC 0.1mm+/-0.01mm  Overall thickness: 1.1mm+/-0.2mm (36 grit)  Aluminium Oxide: Grit grade #36  Holding Medium: Solvent Acrylic Adhesive  Adhesion to steel: 1500g/25mm  Holding Power: 8 Hours/20mm2/kg  Tensile Strength: 6kgf/25mm  Static anti-slip COF: > 0.5  Elongation at break: 25%  Application Temp: -5c to 50c  Resistance to Water: Excellent  Resistance to Grease: Excellent  Staining of Adhesive: No evidence of migration Colours available in #36 Grade Grit  Clear, Black or Yellow Sizes  50mm  25mm available in clear


There are no reviews yet.

Be the first to review “50mm x 18.3m Self Adhesive Anti-slip Tape #36 Grade non-slip Grit – Black”

Your email address will not be published.