Our Extra Fine Clear Spray anti-slip solution is an epoxy aerosol spray that provides a clear, hard, finely textured finish on wood and vinyl surfaces. It is virtually invisible, barefoot-friendly and paw friendly, lead-free and chemical resistant.
Ideal for use on both interior and exterior surfaces where slip resistance is needed. This convenient, easy-to-apply aerosol spray is the perfect solution to treat small or irregularly shaped surfaces and can be used on vinyl, linoleum, wood and many other surfaces. One can covers up to 20 sq. ft.
- Residential & Commercial Use
- Wet Areas
- Wood Stairs
- Wood Decks
- Interior & Exterior Use
- Barefoot Friendly
- Increases Traction
- Easy to Clean
- Weather Resistant
- Fast & Easy Application
â€¢ Extra Fine Non-Slip Spraymust be used in a well-ventilated area.
â€¢ Never use Extra Fine Non-Slip Spray near an open flame.
â€¢ If you scrape, sand or remove old paint from any surface, you may release lead dust. LEAD IS TOXIC. Contact the National Lead Hotline at 1-800-424-LEAD or www.epa.gov/leadRecommended Safety Equipment:
â€¢ Chemical-resistant gloves
â€¢ Eye protection
Varies by surface. Please see chart below for preparation for specific surfaces. ALWAYS: Test a small area for color compatibility and adhesion. For best results, spray between 70-90Â°F / 20-32Â°C. Applying SlipDoctorsâ€™ Non-Slip Spray below 50Â°F/10Â°C will cause the paint to spray and/or dry improperly. Dry time decreases with higher temperatures and increases with lower temperatures.
Step 1:Â TEST: Extra Fine Clear Spray should be tested on a small inconspicuous areabefore full application.
Step 2:Â MIXING: Mix contents of can well by shaking until the ball rattles within the can. Once ball rattles, continue to shake vigorouslyfor 2-3 minutes. During use, shake intermittently for 10 seconds to keep product mixed.
Step 3:Â APPLICATION:Spray 6-12 inches away from surface in a sweeping motion during application. When applying, note that 2-3 light coats will cure, protect and look better that one heavy coat.
Step 4:Â If spray stopsor is irregular, turn can upside down and spray for 2-3 seconds to clear nozzle. Wipe tip, shake can and resume. IMPORTANT: Before storing partial can, clean valve immediately afteruse. To clean: Hold can upside down and spray until only clear gas comes out (approximately 3seconds), then wipe tip and store. If spray nozzle becomes clogged, remove and clean in lacquer thinner.
Step 5:Â CLEAN UP: If overspray occurs, area can be cleaned with paint thinner.
For best results,to remove oily deposits or other foreign matter, apply pH-neutral cleanerat recommended dilution rate and scrub lightly with a soft bristle brush. For general cleaning and maintenance, use a light-pressure rinsing.